Tesla Model 3 Carbon Fibre Spoiler to enhance the look of your Tesla Model 3. These spoiler are real Carbon Fibre. Available in Matte or Gloss finish. Each spoiler comes with a role of adhesive tape to fix your performance spoiler to your Model 3. Hand crafted from Carbon Fibre weave our spoiler will give your Model 3 that performance look. Weighing around 400g this spoiler is light weight, in fact the box weighs more! Tesla Model 3 Carbon Fibre Spoiler Installation. Simply clean the rear boot area with hot soapy water and allow to dry, then using an alcohol cleaning wipe, clean the surface of the boot and and inside area of the spoiler again allowing to dry. Apply the tape to the lower inside of the spoiler in one continuous line, then apply to the upper inside edge in the same manner to form two continuous lines of adhesive tape. Ensure that you do not to run the tape over the edge, otherwise you see it after installation. Firmly press the tape onto the spoiler, the tape is pressure sensitive and the firmer you press the better it will stick. Line up the Tesla Model 3 Carbon Fibre Spoiler to your vehicle ensuring you have it positioned correctly and mark the end positions of the spoiler on the car with masking tape, once you are happy, remove the backing of the tape and fix into position using your masking tape as a guide. Apply pressure to ensure the tape is firmly bonded. You will should start from the middle working outwards towards the sides of the car, pressing it into place, be-careful not to twist the spoiler during installation. All our spoilers come with mounting tape on roll or Pre-Installed On Spoiler Do not apply in cold (below 20deg C) or damp conditions. All our stock is held in the UK.
